Fusion welding of optical fibres/fr

Réaliser une soudure de câble Fibre Optique.

Difficulty

Medium Medium

Duration

10 minute(s) minute(s)

Area

Use

Business

Training

Install Fusion_welding_of_optical_fibres_img15.jpg

• Items

Items

Fusion splicer

The fusion splicer is a tool which delivers fast and reliable fibre splicing under even harsh environmental conditions. It combines portability and ease of use in a ruggedized body.

Fusion splicer

Clipper

The clipper is an instrument for cutting or trimming small pieces of things.

Clipper

Isopropyl alcohol

Isopropyl alcohol is a colorless, flammable chemical compound with a strong odor. It dissolves a wide range of non-polar compounds. Thus, it is used widely as a solvent and as a cleaning fluid, especially for dissolving oils.

Isopropyl alcohol

Step 1 - Préparation des accessoires

Matériel nécessaire : soudeuse, cliveuse, pince à dénuder, lingettes non pelucheuses, alcool isopropylique et protections d'épissure thermorétractables (smooves).

Step 2 - Dénudage et nettoyage de la fibre

Dénuder sur 3/4 cm, nettoyer la fibre dénudée avec l'alcool isopropylique avant de cliver.

NB : ne plus toucher avec les doigts la fibre une fois nettoyée.

Step 3 - Clivage de la fibre

Positionner la fibre dans la rainure adaptée du guide fibre (250 ou 900 µm), la gaine 250 ou 900 µm à la graduation 10 en faisant attention que la partie dénuée prenne bien appui sur les 2 patins.

Step 4 - Positionnement de la fibre dans la soudeuse

Positionner la fibre dans la soudeuse en plaçant son extrémité entre l'alignement des électrodes et le bord de la gorge en V, fermer le clapet de maintien de la fibre.

NB : Attention de ne pas cogner l'extrémité de la fibre au risque d'altérer la qualité du clivage.

Vous devez maintenant répéter ces opérations pour la seconde fibre.

Step 5 - Choix des programmes de la soudeuse

Use the welding program adapted to the type of fibre to be welded, as well as the furnace program adapted to the type of smoove used.

Example: Single mode MS, multi-mode MM and single mode BIF G657.

Step 6 - Welding process

Close the cover to initiate the welding process (the auto start function must be activated otherwise press the green arrow on the keyboard).

Step 7 - Welding evaluation

Three evaluation criteria should be observed: the image quality of the welded fibres (good alignment of the cores, absence of dust or air bubbles, etc.), the estimated loss given by the fusion splicer and the resistance of the fibre to the tensile test (not to be disabled).

Step 8 - Positioning the smoove and shrinkage

Before opening the cover, bring the smoove as close as possible to the fusion splicer, center it at the weld, making sure that the shrinkage will be on the fibre protection sheaths and not on the bare fibre. Position the smoove in the center of the furnace. The furnace is activated automatically if this function has been previously selected in the machine parameters, otherwise press the yellow resistance on the keyboard.

Step 9 - Positioning the smoove on a cassette for winding

After shrinking, position the smoove on the cooling plate before welding other fibres. Then place the smooves in the cassette and wind the fibres.

fr en 1 Published