Search by property

This page provides a simple browsing interface for finding entities described by a property and a named value. Other available search interfaces include the page property search, and the ask query builder.

List of results

• Fusion welding of optical fibres  + (Strip 3/4 cm of the fibre. Clean the bare fibre with isopropyl alcohol before cleaving. '''NB:''' do not touch the fibre with your fingers once it has been cleaned.)
• Fusion welding of optical fibres  + (Strip 3/4 cm of the fibre. Clean the bare fibre with isopropyl alcohol before cleaving. '''NB:''' do not touch the fibre with your fingers once it has been cleaned.)

• Photometric Measurement  + (After switching on the device, check and set the measuring wavelength to 1490 nm, the wavelength of the downlink flow, if necessary. Set the unit of measurement to dBm as stipulated in the operators' procedures.)
• Photometric Measurement  + (After switching on the device, check and set the measuring wavelength to 1490 nm, the wavelength of the downlink flow, if necessary. Set the unit of measurement to dBm as stipulated in the operators' procedures.)
• Descale your Nespresso Pixie machine  + (Before you start, remember to eject the capsule. Empty the capsule tray. Empty the drip tray as well.)
• Descale your Nespresso Pixie machine  + (Before you start, remember to eject the capsule. Empty the capsule tray. Empty the drip tray as well.)
• Localisation visuelle de défauts sur fibre optique  + (Le localisateur visuel de défauts (ou cray … Le localisateur visuel de défauts (ou crayon optique) émet une lumière rouge à une puissance de sortie de 10 mW. Ne pas visualiser directement le faisceau lumineux ou le diriger vers une autre personne. Replacer systématiquement le bouchon de protection après usage. N'allumer l'appareil que lorsque le bouchon de protection est en place ou qu'un connecteur est fixé sur la sortie.u qu'un connecteur est fixé sur la sortie.)
• Soudure par fusion des fibres optiques  + (Positionner la fibre dans la rainure adaptée du guide fibre (250 ou 900 µm), la gaine 250 ou 900 µm à la graduation 10 en faisant attention que la partie dénuée prenne bien appui sur les 2 patins.)
• Visual location of defects on optical fiber  + (The visual defect locator (or optical penc … The visual defect locator (or optical pencil) emits red light at an output power of 10 mW. Do not directly look at the light beam or direct it at another person. Always replace the protective cap after use. Switch on the unit only when the protective cap is in place or a connector is attached to the outlet. or a connector is attached to the outlet.)
• Visual location of defects on optical fiber  + (Press the PWR button. The locator emits a continuous or pulsed signal depending on the setting selected with the MOD button.)
• Fusion welding of optical fibres  + (Position the fibre in the appropriate slot of the fibre guide (250 or 900 µm), the sheath 250 or 900 µm at scale 10, making sure that the devoid part rests firmly on the 2 pads.)
• Fusion welding of optical fibres  + (Tools required: fusion splicer, clipper, stripper, lint-free wipes, isopropyl alcohol and heat-shrinkable splice guards (smooves).)